NOTE: The equipment in this section may be capable of lethal combinations of voltage and current output. HV power supplies and Hipotters will be sold only to businesses or individuals certifying that they are at least 18 years of age. Proof of age may be required.
Bertan Model 230-01R High-voltage
Power Supply- Switchable Polarity.
(Inv
#8170) This stable, low noise high voltage power supply features
front panel digital voltage and current metering and the voltage
output. The rear panel features a connector for remote analog
programming and output voltage and output current
monitoring, line power plug, fuse, and AC voltage selection switch.
It has arc and short circuit protection for safe, reliable, and
arc-free operation. Partial specifications: Output Voltage, Reversible
Polarity: 0 to +/- 1000VDC, Current: 0 to 15mA, Ripple: 10mV.
Power Required: 115/230V, 50/60Hz. Very good used condition, checked,
guaranteed. Requires HV-BNC output cable, not included. Price:
$450.00
Biddle Series 4 "Megger"
Insulation and Resistance Tester. (Inv #8876) Good,
rugged,
hand-cranked model, you don't have to worry about dead batteries.
This one is always ready to go to work for you! Two scales: 0-10,000
Ohms, test voltage 2VDC and 0-infinity (50MegOhms highest marked
value), test voltage 200VDC. You test leads are to be connected
to two cobnenient spring clips on the side of the meter. Very
good used condition, checked, guaranteed. $100.00
Honeywell CE10520 High Voltage
Current Leakage Tester. (Inv #8877) AC
and
DC testing from 0 to 2500 Volts. Main scale reads leakage current
from 0 to 1000 uamps, or 0 to 100 uamps when 1/10 push-button
is pressed. Has an arc detector that sounds during the presence
of arcing on the output. Has nine compensation circuits plus "none"
and external. Good used condition, missing the front cover, checked.
No manual available. Price: $150.00
Keithley 6105 Resistivity
Adapter. (Inv #8878) The Model 6105 Resistivity
Adapter
is a guarded test fixture for measuring volume and surface resistivities
of materials when used with a regulated power supply and an electrometer.
The complete system permits measurement of volume resistivity
from 10^3 to 3 x 10^19 ohm-cm and surface resistivity from 10^3
to 5^18 ohms, in accordance with the procedures of the ASTM. The
adapter can accommodate samples of up to 4" in diameter and
1/4" thick with excitation voltages up to 1000V. Good used
condition, checked, guaranteed. With manual. Price: $185.00